Shower test device
Suitable for external lighting, signal devices and automotive lamp shell protection, can provide realistic analog electronic products and their components during the transportation and use of the spray test may be subjected to water and other environment, to detect the waterproof performance of various products.
Common operation mode
1.Preparation: First, select a test device that can simulate the real rainfall conditions.
A spraying system or spray device can be used to ensure a uniform and continuous flow of rainwater.
2.Sample preparation: Cut the material to be tested into the appropriate size, usually square or rectangular.
Ensure that the edges of the sample are flat, with no obvious defects.
3.Install the samples: attach the sample to the device to ensure full level and withstand rain.
4.Adjust test parameters: adjust the operating parameters of the shower, such as flow and spray Angle.
5.Experimental: turn on the shower and start the experiment.
Usually the experiment lasts for a period of time to simulate the real rainfall process. During the sample surface can be observed, and some key observation points can be recorded.
6.End of the experiment: After the experiment, turn off the rain shower device.
Remove the material and check to see if the wet or wet surface of the sample.
7.Data analysis: to evaluate the waterproof performance of the material according to the experimental results.
The data of water seepage degree and water seepage time can be recorded for analysis and comparison.
satisfying criteria:
IEC 60529, EN 60529, IEC 60068-2-18, IEC 60598-1, IEC 60950-1, GB/T 2423.38, GB/T 4208, GB/T 4942.2, GB/T 7000.1, GB/T 30038, ISO 20653,etc.
评论
发表评论